Abstract:
The Electrical Discharge Machining process is used widely for making tools, dies, deep hole
drilling, metal disintegration machining and close loop manufacturing. Material removal in EDM
takes place due to thermal erosion as a result of discrete repeated discharges that take place
between the tool and the work piece. A dielectric fluid plays a significant role on the machining
efficiency of Electric discharge machining (EDM). On the basis of number of phases involved in
dielectric fluid EDM process can be categorized.
Two phase (liquid-air) dielectric medium is utilized in near-dry (EDM). It is an environmentally
friendly process. In near dry EDM the dielectric medium is in the form of vapour or mist bubble.
According to the research work done as of yet, flushing after machining depths more than 10mm
has been one of the short comings of the process. Debris reattachment to tool causes side sparks
leading to poor quality characteristics or outcomes of process like hole overcut.
The main objective of this study was to come out with solutions to enhance the flushing of IEG
and thereby improve MRR, reduce hole overcut and study tool wear rate. For this purpose flow
characteristics of bi-phase mixture in IEG and its vicinity was simulated using ANSYS fluent 19.0
where inlet conditions namely, air pressure and liquid flow rate were altered along with three
different geometries of tool electrode. Results of simulation indicated that tool geometry with
helical flutes was most effective for deep holes since it provided maximum velocity in IEG
(392m/s) with velocity vectors pointing out of drilled holes, tool with peripheral slots was also
effective with high pressure and high liquid flow rate.
Further experimental results pointed out that MRR was highest when tool with helical flutes were
used, although hole over cut was minimum with tool having peripheral slots and it was concluded
by ANOVA that tool geometry was of utmost importance to control MRR and TWR but had
minimal effect on hole overcut while pressure is most influencing flow parameter to control hole
overcut.
