Al alloys has high strength, low density, good wear resistance, low coefficient of thermal expansion. Its low density, which can contribute significantly to the aspect of weight savings in the design and construction of ...

High-temperature corrosion-resistant coatings is required so that the service lifetime of components used at higher temperatures in corrosive environments can be prolonged Boiler steels which are subjected to high temperature ...

Nickel—Molybdenum alloy was electrodeposited from phosphate baths. The effect of Molybdenum atomic percentage was investigated. The cyclic voltammetry was performed at different pH values in order to determine the reduction ...

Stainless steels (chromium content > 11%) are used extensively in the power generation, pulp and paper, and chemical processing industries, but are also chosen for use in many everyday household and commercial products. Joining ...

Dual phase steels are being used in automobile industries for last three decades. The mechanical properties of dual phase steels can be altered by varying its martensite volume fraction. However, the benefits obtained in ...

Gas Metal Arc Welding (GMAW) of Cast Al (Mg)—A1203 particulate composite has been investigated in respect of Heat Input. The composites have been synthesized in the laboratory here by stircasting technique and the plates ...

High -strength steels have often .tensile strengths in excess of 600 MPa. Those with strengths up to '1000 MPa are called ultra high strength steels. These steels contain carbon in the same range as mild steels, but in ...

Nickel-Graphite graded material has been prepared by a powder metallurgy die compaction process followed by sintering subsequently cold rolling operation. The final, sintered samples have a gradient in carbon content, ...

An attempt has been made to develop dual phase (d-p) steels from cold-rolled plain carbon sheet steels. The plain carbon sheet steel is of 1 mm thickness and the chemical composition(wt%) is C-0.06, Si-0.04, Mn-0.5, S-0.03 ...

Due to immense potential of High Carbon Steel in the making of tool and die and machine component. It is very important to know the friction and wear aspect of high carbon steel. In the present work a plain high carbon ...